Almost all men who have the right materials and who have minimal skills in handling special tools – almost all of them can install a bath in their house on their own.
For installation, you will need to prepare:
1) Actually, the bathtub specifically selected by the necessary sizes;
2) sealing composition;
3) a solution of sand and cement;
4) mounting polyurethane foam;
5) oil paintwork.
First, the floor plastic siphon with the necessary overflows and properly equipped release will be equipped. You will be interested in the restoration of van Kyiv.
You can also use a reliable cast -iron siphon, which is equipped with a strong brass release. After preparing the siphon, the legs are attached to the new bath.
After that, the bath moves to the wall. The bath should take a special position: so that the bell can be easily attached to the pipe of the home sewer system.
Now the legs must be adjusted so that a slight slope appears towards the release of the bath. Cement-sand mortar is seized with the joint, which remains between the siphon and the pipe of the sewer system.
Also, if the bathtub is located right against the wall, you need to seal the edges of the bathtub. In case of detection of even the smallest cracks between the bathtub and the wall, they must be well covered with slightly diluted cement (consistency of liquid sour cream).
Immediately after the solution completely dries, it is necessary to paint this frozen cement on an oil basis. This paint material, of course, should be chosen taking into account the color of the new bath. Experienced craftsmen also advise treating seams with a sealant on a silicone base. Accordingly, if at the end of the work between the wall and the bathroom very wide cracks remain, then before the use of cement and sealant, wide sealing gaskets must be used.