The first thing you should do before the start of construction is to build your bathhouse foundation. Usually people make a columnar foundation. Since the design of this bathhouse is very simple you do not need to make a continuous melodic strip foundation.
You can use asbocet pipes that are filled with concrete solution before this or use reinforced concrete blocks. If you try, then you will get a great frame-shield with your own hands. Of course, the first thing you should do is to prepare a place for the construction of your bathhouse, the site on which you will build a frame-shchel bath with your own hands, the site must first be leveled.
You should also think through the moment where the flow of water will be, since this is a very important point. If you make a small bath, which you will use only in the summer, then it is not necessary to make a septic tank, it will be enough to organize the stock in a regular ditch, which is located outside the bathhouse. Many people do not think about this issue at all because the water goes through the cracks that are in the floor and is absorbed into the ground, but if you do not want to use it then you need to do water drainage.
We also recommend reading an article on the topic – how to build a house cheaply, and now we continue:
If a small number of people use the bath and not so often then nothing to worry. But in this case, you will need to change the floor, at least once for five years or even more often because it will rot. It is better, of course, to spend a little time and effort and make a stock device. On the selected site, using the pegs, the future foundation of the bathhouse is marked after that pipes are dug up about a depth of one and a half meters, which are filled after a concrete solution. Then you need to lay the basement of the frame. For the frame, a beam is used, for example, from coniferous trees, a tree must be impregnated with a special antiseptic for baths.
The basis for which the frame is being built is made from the beam with a minimum section. The corners of the timber are connected in a paw or half -ceremony. If you need additional fastening, then the basement beam is attached with nails to the foundation. Then you need to install vertical racks and upper strapping. After this, install the supporting frame racks. They must be installed in different corners and so in those places where internal partitions are being built. Pay attention to the fact that the bar for the loading walls of the bath should have a cross -section a little more than for ordinary racks.
We advise a video on the topic: Bath panel 2.5 meters width-4.5 meters long