K+M Carbide Cutting Pilot w/Flutes, 26 Calibre/6.5MM Cleaning Rod Calibre_.375 Calibre 001" smaller than the bullet

001" smaller than the bullet diameter with an estimated

This result was made possible by Lapua’s consistent quality that starts with the raw materials of the bullet

A pivoting bipod will allow the shooter to compensate for ground that is not level by up to 20 degrees

Consistent

607 Ballistic Coefficient G7 0

K+M Carbide Cutting Pilot w/Flutes, 26 Calibre/6.5MM Cleaning Rod Calibre_.375 Calibre 001" smaller than the bulletThis finely ground carbide cutting pilot, designed for use with the K+M case neck turning body, has four cutting flutes used to remove the doughnut that can form at the inside neck wall and shoulder junction. If you are noticing the formation of a doughnut, this tool will remove the excess material without affecting inside neck diameter allowing for uniform bullet seating and eliminate powder gas restriction. There is also less friction between brass